What roof systems does Solar Stack work with?
Sloped Systems: Tile, Concrete Decks, Structural Metal (22 gauge or heavier)
Flat Deck & Low Slope Systems: Granulated Cap Sheet (Roll Roofing), BUR (Built Up Roofing), Modified Bitumen, TPO, EPDM, PVC, Hypalon, SPF (Spray Polyurethane Foam), Concrete Decks, Structural Metal (22 gauge or heavier).
What roof systems does Solar Stack NOT work with?
Solar Stack does not work with shingle, silicone or polypropylene-based surfaces.
Do I need rails?
Solar Stack eliminates the need for rails and racks. Instead, your additional mounting hardware can be installed directly to Solar Stack. This allows you to install solar panels directly to our pedestal. We have two quarter-inch channels and a half-inch channel allowing you to use any mid-clamps and end-clamps on the market with our system.
What about wire management?
Contractors can either run their wire management from pedestal to pedestal with cable ties or they can use solar panel clips.
Where can I find engineering reports?
Please visit our Technical Page for official certifications and engineering reports.
Is a primer required for adhesion to the foam adhesive?
A primer is not required but is recommended for most roof systems. Please email [email protected] for more information.
